Bently Nevada 330104-00-02-20-01-00 8mm Probe

Product Overview

The Bently Nevada 330104-00-02-20-01-00 is a 3300 XL 8 mm proximity probe with M10×1 thread and armor protection. Its 20 mm case and 2.0-metre cable handle turbine and compressor monitoring where longer cable runs are needed. The probe weighs approximately 0.25 kg (0.55 lb).

Ordering Code Breakdown

330104 – 3300 XL 8 mm Probe, M10 x 1 thread, with armor
00 – Unthreaded Length: 0 mm
02 – Overall Case Length: 20 mm
20 – Total Cable Length: 2.0 metres (6.6 ft)
01 – Connector: Miniature coaxial ClickLoc with connector protector, standard cable
00 – Agency Approval: Not required

Technical Specifications

Engineering Advantages

The 2.0-metre cable supports remote mounting without extension cables, reducing connection points and potential failure sites. The ClickLoc connector protector shields the interface from mechanical damage during installation. Armored M10×1 housing resists abrasion in high-vibration areas. At roughly 0.25 kg, the probe adds minimal mass to the mounting point.

Technical FAQs

Q1: What is the probe DC resistance?
A1: 7.88 ± 0.50 Ω for the 2.0-metre probe length.

Q2: What is the recommended gap setting?
A2: 1.27 mm (50 mils) using an AISI 4140 steel target.

Q3: What connector type does this probe use?
A3: Miniature coaxial ClickLoc with connector protector and standard cable.